Hi there.
I have purchased a RAMPS 1,4 board + Arduino MEGA 2560 R3. I have uploaded Teacup firmware. Heatbed and Extruder heater seems to heat and temp reading seams about to be right. Extruder motor works right. BUT none of my X,Y or Z axis are moving at all. ( I have checked the different motors by hooking them up to the extruder and they all work, so it is not a matter of wrong cable connection.) So i started looking a little at the pin assignment. I think i have wrong pin assignment. I see pin 54 for the x axis, when i look at the RAMPS wiki, but on the Teacup is shows DIO01.
How to assign pins ?
Any help appreciated
Wang Fei
PS : I did post this some hrs. ago, but it kind of positioned it self in General !!! sorry for that
I have purchased a RAMPS 1,4 board + Arduino MEGA 2560 R3. I have uploaded Teacup firmware. Heatbed and Extruder heater seems to heat and temp reading seams about to be right. Extruder motor works right. BUT none of my X,Y or Z axis are moving at all. ( I have checked the different motors by hooking them up to the extruder and they all work, so it is not a matter of wrong cable connection.) So i started looking a little at the pin assignment. I think i have wrong pin assignment. I see pin 54 for the x axis, when i look at the RAMPS wiki, but on the Teacup is shows DIO01.
How to assign pins ?
Any help appreciated
Wang Fei
PS : I did post this some hrs. ago, but it kind of positioned it self in General !!! sorry for that