Greetings!
Several months ago I had a PC issue, requiring a wipe and reload - I still have my original marlin folders, but am unsure which one is currently loaded. At the time of the wipe and reload (and currently) the printer is very much dialed in. I'd very much like to avoid messing up any of the existing settings.
The issue is I'm currently attempting to add an additional extruder, and would need to flash with updated settings to control the 6th stepper motor, second hot end and the additional thermistor.
Any ideas in how to export a currently loaded config from a Ramps 1.4 board?
Several months ago I had a PC issue, requiring a wipe and reload - I still have my original marlin folders, but am unsure which one is currently loaded. At the time of the wipe and reload (and currently) the printer is very much dialed in. I'd very much like to avoid messing up any of the existing settings.
The issue is I'm currently attempting to add an additional extruder, and would need to flash with updated settings to control the 6th stepper motor, second hot end and the additional thermistor.
Any ideas in how to export a currently loaded config from a Ramps 1.4 board?