Sorry if this has been posted elsewhere, but I have yet to see this problem before. I followed the wiki page on wiring the ramps 1.4 board. Installed the USB drivers, and all the electrical components except the heated bed. I can connect to the printer and successfully change temperatures for the hot end. I am having a problem with my stepper motors though.
When I plug in my power supply to the ramps board and turn it on, my motors immediately start moving towards the endstops, and won't stop even when they activate the endstops. They just continue to move and I can't control them.
Thanks for any guidance to this problem!
When I plug in my power supply to the ramps board and turn it on, my motors immediately start moving towards the endstops, and won't stop even when they activate the endstops. They just continue to move and I can't control them.
Thanks for any guidance to this problem!