I want to buy the parts and built a SDRAMPS (http://reprap.org/wiki/Sdramps), but the BOM is a little vague about the exact specs of the parts needed. I put in all of the provided specs on Mouser.com, but there's still some of them that I could use some help on. Here's the specs I'd like to know on the parts:
The Capacitor:
___Voltage Rating - 4 to 35v
___Tolerance - 5, 10, or 20%
___Resistance - 1.5 to 25 Ohms
The LED:
___Forward Voltage - 1.7 to 2.1v
The Resistor:
___Power Rating - 33mW to 1W
What would be best to pick for these values?
Until I find out how to delete this, I found what I was looking for. So you can disregard this post.
The Capacitor:
___Voltage Rating - 4 to 35v
___Tolerance - 5, 10, or 20%
___Resistance - 1.5 to 25 Ohms
The LED:
___Forward Voltage - 1.7 to 2.1v
The Resistor:
___Power Rating - 33mW to 1W
What would be best to pick for these values?
Until I find out how to delete this, I found what I was looking for. So you can disregard this post.