I have slowly been building my MendelMAX 1.5 and recently purchased Ramps 1.4 and a Full Graphic LCD for it - This one -. The ramps board I purchased is also from this seller. I am having 2 issues with the controller, first the rotary encoder is inverted. If I turn it clockwise it reduces the feedrate and increases when turned counter clockwise. The other issue I am having is the display will not dim no matter jumper or pot settings. The dimming is not too much of an issue as I did not need this feature but the encoder is going to make me crazy, I know it. I was wondering if anyone could help me out. I spent most of last night searching for solutions and - this - is all I could find. I was unable to find the code that it is referring to. I am running Marlin, and Arduino 1.0.5-r2 . Thanks for helping me out!
Also, As far as I can tell these are the only issues, my thermisters, steppers, and heated bed are getting ordered next week so I am unable to test the functionality of those with the controller.
Also, As far as I can tell these are the only issues, my thermisters, steppers, and heated bed are getting ordered next week so I am unable to test the functionality of those with the controller.