From the RepRap RAMPS 1.4 Wiki we read: "From left to right, wire all of the stepper motor's wires as red, blue, green, and black ... ."
The motor connectors I have are are opposite for the red and blue. They are: BLUE first and then RED. (Green and black are as per the Wiki.)
Should I reverse those first two in the housings I have so their order matches the Wiki (red first)?
OR, is the position of RED and BLUE interchangeable?
OR, do different board manufacturers require different wire orders?
I've seen all different orders and color combinations when I did an image search for RAMPS so that was no help.
Again, I really appreciate any advice. Thanks!
The motor connectors I have are are opposite for the red and blue. They are: BLUE first and then RED. (Green and black are as per the Wiki.)
Should I reverse those first two in the housings I have so their order matches the Wiki (red first)?
OR, is the position of RED and BLUE interchangeable?
OR, do different board manufacturers require different wire orders?
I've seen all different orders and color combinations when I did an image search for RAMPS so that was no help.
Again, I really appreciate any advice. Thanks!