Hi guys,
so I had an issue with one of my mosfets (for D10) just like the guy here [www.printrbottalk.com]. Today I replaced the mosfet and powered up the printer.
Previously the fan for my e3d hotend would not power up on start up (it is in series with the hot end wires which connect to D10 and +12v) and it was working now so I thought it was fixed.
I connected pronterface and It there is a 1-2 second delay on each command on the left interface and I cannot receive a reply to M114 or M119.
When I replaced the mosfet I accidently took off a resistor, but I put it back afterwards.
any ideas ?
Thanks heaps (the printer was working 100 % before - I think I blew the mosfet when the two bed fan wires short circuited )
so I had an issue with one of my mosfets (for D10) just like the guy here [www.printrbottalk.com]. Today I replaced the mosfet and powered up the printer.
Previously the fan for my e3d hotend would not power up on start up (it is in series with the hot end wires which connect to D10 and +12v) and it was working now so I thought it was fixed.
I connected pronterface and It there is a 1-2 second delay on each command on the left interface and I cannot receive a reply to M114 or M119.
When I replaced the mosfet I accidently took off a resistor, but I put it back afterwards.
any ideas ?
Thanks heaps (the printer was working 100 % before - I think I blew the mosfet when the two bed fan wires short circuited )