Today I received my new opto's, to replace the Orca 4-wire opto's (Gen6) for 3-wire opto's to the Ramps.
Mine are V19 1028 / TCST 2103 with a 3-wire flat cable which has 3 separate one-pin connector at the end.
Is there a specific order to plug them in the ramps ? I presume middle wire in the middle, but for the rest ?
The wires are marked :
1) dot dash
2 long dash
3 small text sentences , not readable on my age, not even with mg
Thomas
Mine are V19 1028 / TCST 2103 with a 3-wire flat cable which has 3 separate one-pin connector at the end.
Is there a specific order to plug them in the ramps ? I presume middle wire in the middle, but for the rest ?
The wires are marked :
1) dot dash
2 long dash
3 small text sentences , not readable on my age, not even with mg
Thomas