So, in Marlin, board config 35 corresponds to a RAMPS board where D10 is the extruder, and D9 and D8 are pwm controllable fans. Is there any easy way where D10 could also be treated as a PWM controlled fan in the firmware?
If this isn't easy to do, then by installing the reprap fan extender (http://www.geeetech.com/wiki/index.php/Reprap_Ramps1.4_RRD_Fan_Extender), would I be able to successful add another set of pwm controlled pins?
If this isn't easy to do, then by installing the reprap fan extender (http://www.geeetech.com/wiki/index.php/Reprap_Ramps1.4_RRD_Fan_Extender), would I be able to successful add another set of pwm controlled pins?