Is there any way either through a setting I'm missing or something in code for a marlin setup that I can change to get the fan on D9, I'm using it as the extruder fan for a direct drive extruder, to stay on as long as the extruder is above a specific temperature? Right now after a print is finished and the printer parks and everything gets turned off including the fan but the extruder is still very hot. I've been manually turning the fan back on at the end of a print but longer prints would not have me around to do this.
I'm new to 3d printing and really new to Marlin so if I'm missing an obvious solution just beat me over the head with it until it sinks in. :S
I'm new to 3d printing and really new to Marlin so if I'm missing an obvious solution just beat me over the head with it until it sinks in. :S