Hello guys,
Long time reader first time poster. I have a flashforge creator x and am currently building a Rostock delta.
The ramps board all came pre assembled/attached. Here's the link [www.ebay.com.au]
Upon connecting the 12v supply, the regulator on the mega got very hot and burned the trace leading from d1.
Upon testing on a breadboard, all but one of the stepper drivers are faulty.
What could cause this to happen? Obviously the faults with the drivers caused excessive current to be drawn from the mega through the trace that burnt.
The seller is trying to argue that I connected the endstops incorrectly or that my power supply is faulty.
From all my knowledge and experience this should not have happened. Most basic connections only.
Any advice appreciated,
Cheers
Ash
Long time reader first time poster. I have a flashforge creator x and am currently building a Rostock delta.
The ramps board all came pre assembled/attached. Here's the link [www.ebay.com.au]
Upon connecting the 12v supply, the regulator on the mega got very hot and burned the trace leading from d1.
Upon testing on a breadboard, all but one of the stepper drivers are faulty.
What could cause this to happen? Obviously the faults with the drivers caused excessive current to be drawn from the mega through the trace that burnt.
The seller is trying to argue that I connected the endstops incorrectly or that my power supply is faulty.
From all my knowledge and experience this should not have happened. Most basic connections only.
Any advice appreciated,
Cheers
Ash