Hi,
Just finished designing and building a printer based on ramps 1.4 running on Marlin. End stops are Mech Endstops v1.2 wired with 3 wires. I use end stops in both ends of each axis to prevent crashing if running to far out. The end stops works just fine when i connect to the printer, if I run one of the axis and hit the corresponding end stop the stepper will stop. The same when running a homing cycle, the end stops works just fine.
However AFTER running a homing cycle the end stops doesn't respond anymore if I hit one of the end stops while running a single axis or during a print. Homing still works though. If i reset the printer the end stops works again. Also, when using M119 the status of the end stops display correct any time.
Thankful for any ideas on what I can do to make the end stops work as they should..
Blim
Just finished designing and building a printer based on ramps 1.4 running on Marlin. End stops are Mech Endstops v1.2 wired with 3 wires. I use end stops in both ends of each axis to prevent crashing if running to far out. The end stops works just fine when i connect to the printer, if I run one of the axis and hit the corresponding end stop the stepper will stop. The same when running a homing cycle, the end stops works just fine.
However AFTER running a homing cycle the end stops doesn't respond anymore if I hit one of the end stops while running a single axis or during a print. Homing still works though. If i reset the printer the end stops works again. Also, when using M119 the status of the end stops display correct any time.
Thankful for any ideas on what I can do to make the end stops work as they should..
Blim