Hi!
I use Marlin firmware in combination with RAMPS 1.4 for a Delta Printer and want to enable Auto Bed Levelling. This should just be a matter of adding a stepper motor and end stop, updating the configuration of the Marlin and using the G30 command to start.
Sadly, when I have updated the configuration, and try to use the G30 command, the stepper motor does move, but it moves first to the calibration position but directly moves back to the original position.
It does the same if I use a G28 command.
As a result, the end stop is not deployed during calibration, and it will not work...
Does anybody have experience with the Auto Bed Levelling of the Marlin firmware? It seems that there is some kind of issue with the firmware?
Thanks!
I use Marlin firmware in combination with RAMPS 1.4 for a Delta Printer and want to enable Auto Bed Levelling. This should just be a matter of adding a stepper motor and end stop, updating the configuration of the Marlin and using the G30 command to start.
Sadly, when I have updated the configuration, and try to use the G30 command, the stepper motor does move, but it moves first to the calibration position but directly moves back to the original position.
It does the same if I use a G28 command.
As a result, the end stop is not deployed during calibration, and it will not work...
Does anybody have experience with the Auto Bed Levelling of the Marlin firmware? It seems that there is some kind of issue with the firmware?
Thanks!