I tested my ramps 1.4 board with ramps test..its working fine with x and y motors running and 4 leds flashing.but when i uploded marlin firmware with all configuration like motherboard 33 and uncommenting ramps from pins.h file and even baud rate is matching with Repetier host software as 250000.
My problem is with marlin and repetier host manual control motors are not moving.
I searched a lot and found some ways but all are not working for me.
Anybody has any suggestions?
I am attaching 2 motors X and Y with polulu stepstick and solenoid on D9 port with no endstops.does it matter?
My problem is with marlin and repetier host manual control motors are not moving.
I searched a lot and found some ways but all are not working for me.
Anybody has any suggestions?
I am attaching 2 motors X and Y with polulu stepstick and solenoid on D9 port with no endstops.does it matter?