i have an old 203watt xbox power supply because that seems to be what many people were using to power ramps electronics, and have read a bunch of people's tutorials or wiring diagrams but would like to check with you guys.
this blog:
[reprapsquad.wordpress.com]
has a wiring guide but seems to miss out which screw terminals go where,- or maybe he says to put them only in the 11amp terminals from this photo-
[reprapsquad.files.wordpress.com]
there is no heated printbed to power, will this power the 5 motors and not damage anything?
it has 12 volts,will the board just draw the necessary current for what it needs?
thanks
this blog:
[reprapsquad.wordpress.com]
has a wiring guide but seems to miss out which screw terminals go where,- or maybe he says to put them only in the 11amp terminals from this photo-
[reprapsquad.files.wordpress.com]
there is no heated printbed to power, will this power the 5 motors and not damage anything?
it has 12 volts,will the board just draw the necessary current for what it needs?
thanks