Hello. This is my first post. Hope you guys can help me.
I have a ramps 1.4 with mega 2560
At this point when I send the command, it heats up the bed but the temperature doesn’t read on pronterface or cura. The hot end does not respond, and it's reading the room temperature. The red light in on.
On the multimeter D08 it reads 11,40 and both D09 and D10 reads 0
Note: I know next to nothing about electronics and I appreciate the patience.
I have a ramps 1.4 with mega 2560
At this point when I send the command, it heats up the bed but the temperature doesn’t read on pronterface or cura. The hot end does not respond, and it's reading the room temperature. The red light in on.
On the multimeter D08 it reads 11,40 and both D09 and D10 reads 0
Note: I know next to nothing about electronics and I appreciate the patience.