This is my first time using a RAMPS board and Marlin firmware, and I'm running into some issues.
I'm running some initial tests of a corexy setup and whenever I send a motion command and the motors will make a high pitched noise and make a jerking motion instead of a slow, smooth movement. I'm assuming the issue is related to the motor currents or something in the configuration.h file, but I haven't found it yet.
Has anyone had this problem before?
I'm running some initial tests of a corexy setup and whenever I send a motion command and the motors will make a high pitched noise and make a jerking motion instead of a slow, smooth movement. I'm assuming the issue is related to the motor currents or something in the configuration.h file, but I haven't found it yet.
Has anyone had this problem before?