As someone who has been frustrated one too many times struggling to put the tiny little thermistor into it's tiny little hole only to have it's leg snap off soon after, I began to look for something better. E3D being as innovative as they are released an upgrade kit for the V6. This kit replaces the old heater block with a new one capable of fitting a PT100 thermal sensor instead of a thermistor. Link to the store here [e3d-online.com] . Has anyone tried this new setup with their RAMPs board yet? From what I've seen it is a simple plug and play with ultimaker and requires a new setting in marlin or repeiter to work properly. While looking online however I haven't found any guides on how to connect the new sensor to the board. I know that ramps requires a break out board that is included in the kit but I'm not sure exactly how it connects to the rest of the board. If anyone with experience could help me I would greatly appreciate it.
↧