12864 LCD + RAMPS 1.4 - momentary switch problems (2 replies)

Hi all,

I have a problem with the switch in the rotary knob, in the newest marlin firmware the knob and the click on the knob doesn't work at all:


But with older marlin firmware (i used it on my sanguinolulu setup, and edited the motherboard for the ramps 1.4) the knob does work (reversed but that's no problem and fixable),
but the click is registered double or something, i can see the menu in a flash and then i goes back, when i click a lot sometimes i stay in the menu, but if i want to get a layer deeper i have the same problem:


I do have a momentary switch i can hook up and set the pins to, i tried pin 63 (so pin 63 & 5v are connected with a switch in between) on AUX-2, but that didn't work at all...

Thanks in advance, i really hope someone is able to help me! Searched other topics, but i didn't find any with the same problem!