Hello to all
I am actually new to 3d printers , i have searched for the best solution but i haven't find a clear answer to this , sorry if it has been asked before .
I need four extruders driver for my new ( and the first ) 3d printer , after lots of searches i have decided to use RAMPS for this reasons that I can use and test different firmwares such as Marlin, RepRap and Repetier on it.
First of all if cost doesn't matter that much ( of course it matters but i meant if paying a little bit more makes it a lot easier , i will pay for that ) is it wise choice ?
Second of all , is it possible to Use that for 4 different extruders or not ? if yes how ? is there a tutorial for that ? because all i could find is this which only says how to add the third extruder nothing about the fourth one.
Third question is that , How about using RUMBO , RAADS and Azteeg for this purpose ?
fourth and the last question , is there any online store that u suggest for buying from china ? some reliable distributer for the electronics stuff needed ?!
I am actually new to 3d printers , i have searched for the best solution but i haven't find a clear answer to this , sorry if it has been asked before .
I need four extruders driver for my new ( and the first ) 3d printer , after lots of searches i have decided to use RAMPS for this reasons that I can use and test different firmwares such as Marlin, RepRap and Repetier on it.
First of all if cost doesn't matter that much ( of course it matters but i meant if paying a little bit more makes it a lot easier , i will pay for that ) is it wise choice ?
Second of all , is it possible to Use that for 4 different extruders or not ? if yes how ? is there a tutorial for that ? because all i could find is this which only says how to add the third extruder nothing about the fourth one.
Third question is that , How about using RUMBO , RAADS and Azteeg for this purpose ?
fourth and the last question , is there any online store that u suggest for buying from china ? some reliable distributer for the electronics stuff needed ?!