Hi i am building my own dual extrusion 3D printer. I have RAMPS with defined Motherboard_14_EEB and connected two thermal sensor 1 at T0 and another one at T1. The printer doesnt contain any heatbed.
Scenario:
Temp sensor both classified as 1 in Marlin.
T0 shows 25degC room temperature and is able to heat up.
T1 shows 0degC.
Swapped T0 to T1,
new T0 now shows 0degC and T1 also 0degC.
Please help.
Scenario:
Temp sensor both classified as 1 in Marlin.
T0 shows 25degC room temperature and is able to heat up.
T1 shows 0degC.
Swapped T0 to T1,
new T0 now shows 0degC and T1 also 0degC.
Please help.