Hey guys,
Setting up my new CoreXY machine and would like to just double check that my wiring is correct and safe seeing as there is mains voltage for the heatbed.
I have attached an image of how i believe it should be wired up as to be safe.
The board will be directly soldered to with the connectors removed as I have had them fail more then once over the last few years on my Prusa I2.
![Ramps_Mains.png]( "Ramps_Mains.png")
[attachment 82598 RampsMains1.png]
Cheers,
Alex
Setting up my new CoreXY machine and would like to just double check that my wiring is correct and safe seeing as there is mains voltage for the heatbed.
I have attached an image of how i believe it should be wired up as to be safe.
The board will be directly soldered to with the connectors removed as I have had them fail more then once over the last few years on my Prusa I2.
[attachment 82598 RampsMains1.png]
Cheers,
Alex