Hi,
I had tried to search if this happened to anyone before but could not find anything so far. Whenever I am starting a print with heated bed target temp to be above 100 the last degree is not reached.
Example
Target 115
Heating reached 114
Target 110
Heating reached 109
Bed is insulated with a thick cork and I tried PID autotune several times. It seems like its somewhat more of software related problem than hardware ( which too could do with improving but thats not my point here)
When I want to print with 110 I would set up slicer to preheat to 111 and then go to Tune> Temp> Bed and... well here max I can manually set it to is always 105 C!!!
Help anyone?
I had tried to search if this happened to anyone before but could not find anything so far. Whenever I am starting a print with heated bed target temp to be above 100 the last degree is not reached.
Example
Target 115
Heating reached 114
Target 110
Heating reached 109
Bed is insulated with a thick cork and I tried PID autotune several times. It seems like its somewhat more of software related problem than hardware ( which too could do with improving but thats not my point here)
When I want to print with 110 I would set up slicer to preheat to 111 and then go to Tune> Temp> Bed and... well here max I can manually set it to is always 105 C!!!
Help anyone?