Hi
I have a CoreXY printer 300*300mm. My heated bed runs on 12volt (or 24V) and it take a long time for it to reach temperature.
Is it possible to use a 24volt PSU for the heated bed and some sort of relay between the PSU and the connector on the Ramps?
All the rest of the elektronics in running on 12 volt.
Thank you
I have a CoreXY printer 300*300mm. My heated bed runs on 12volt (or 24V) and it take a long time for it to reach temperature.
Is it possible to use a 24volt PSU for the heated bed and some sort of relay between the PSU and the connector on the Ramps?
All the rest of the elektronics in running on 12 volt.
Thank you