HI,
My flsun i3 plus works well but has an annoying habit of randomly rebooting as the bed heats up before printing starts.
What would you do?
I am thinking this might be momentary power shortage to the arduino mega. So if I added a biggish - say 1000uF capacitor across GND and 5V somewhere (e.g. near USB connector) would that be likely to work?
The MKS Gen L v1.0 board seems to be RAMPS 1.4 and arduino mega combined on one board.
I have a spare mosfet board - would running the hotbed using this on the same power supply help? If separate power needed I could use an old PC power supply - would you use this as the main power or the hotbed power.I assume the hotbed uses the most power.
Thanks for any help and suggestions.
M
My flsun i3 plus works well but has an annoying habit of randomly rebooting as the bed heats up before printing starts.
What would you do?
I am thinking this might be momentary power shortage to the arduino mega. So if I added a biggish - say 1000uF capacitor across GND and 5V somewhere (e.g. near USB connector) would that be likely to work?
The MKS Gen L v1.0 board seems to be RAMPS 1.4 and arduino mega combined on one board.
I have a spare mosfet board - would running the hotbed using this on the same power supply help? If separate power needed I could use an old PC power supply - would you use this as the main power or the hotbed power.I assume the hotbed uses the most power.
Thanks for any help and suggestions.
M