Hi guys,
I would like to add an RGB strip to my printer that can be controlled via Marlin. There's already a lot to find, but mostly for regular RGB strips, which use 3 pins on the board and have to be equipped with transistors.
Now since Marlin has support for NeoPixel/WS2812B LEDs, that would simplify the whole thing. Power the strip externally with 5V and add only one wire for control on board, as far as I understand it. Has anyone had any experience with the Trigorilla board? And if yes, which pin would be suitable?
Best regards,
David
I would like to add an RGB strip to my printer that can be controlled via Marlin. There's already a lot to find, but mostly for regular RGB strips, which use 3 pins on the board and have to be equipped with transistors.
Now since Marlin has support for NeoPixel/WS2812B LEDs, that would simplify the whole thing. Power the strip externally with 5V and add only one wire for control on board, as far as I understand it. Has anyone had any experience with the Trigorilla board? And if yes, which pin would be suitable?
Best regards,
David