Dear all,
I want power a Ranps 1.4 board with 24V. I read that I have to remove the D1 diode, check all capacitor ratings and replace the fuses.
In my case, I only want to drive the stepper motor's with the ramps board (no heating bed). I saw there was a 30V fuse connected to the 5A line and a 16V connected to the 11A line. If I were to remove the D1 diode and only use the stepper motor 5A power line, can I then just leave the fuses that are already on the board?
Or is it still recommended to replace the fuses?
Greetings, Robin
I want power a Ranps 1.4 board with 24V. I read that I have to remove the D1 diode, check all capacitor ratings and replace the fuses.
In my case, I only want to drive the stepper motor's with the ramps board (no heating bed). I saw there was a 30V fuse connected to the 5A line and a 16V connected to the 11A line. If I were to remove the D1 diode and only use the stepper motor 5A power line, can I then just leave the fuses that are already on the board?
Or is it still recommended to replace the fuses?
Greetings, Robin