Problem with output D10 (no replies)
Hello. I built a homemade printer using ramps 1.4 and I have a problem with the extruder. When I energize the ramps, the extruder starts to heat up and continues indefinitely (it only stops heating...
View ArticlePreheat test damaged the board - ramps 1.4 (1 reply)
Hello everyone, I'm building a custom 3d printer using ramps 1.4 board. Thanks to reprap community, I've completed to run motors and endstoppers very quickly. I have connected the mk3 heatbed to D8...
View ArticleMy RAMPS1.4 doesn't work when controlled by Raspberry PI 5 via Python3 (no...
Hello, When I use my Windows device to control ramps1.4 (mounted on mega Arduino) via Python3, by g code like this: ... import serial import time myPort = serial.Serial('COM7', 250000, parity='N')...
View ArticleFaulty thermistor readings on RAMPS 1.4 (no replies)
Hi, I've got an MKS Gen-2Z v1.1 control board based on RAMPS 1.4 and recently after starting the printer the heated bed readings are fluctuating. If I try to heat the bed the LED is lighting up and...
View ArticleWrong Axis is moving:( (6 replies)
Hi there, I have set up a custom built printer using Ramps 1.4 and Marlin. My problem is that when i want to move z the x axis moves everything else is completely working and ok. Thanks for any help....
View ArticleRamps 1.4 fuses (2 replies)
Dear all, I want power a Ranps 1.4 board with 24V. I read that I have to remove the D1 diode, check all capacitor ratings and replace the fuses. In my case, I only want to drive the stepper motor's...
View ArticleRamps 1.4 > 1.6 "No data" (no replies)
Hello On a printer I just changed the ramps 1.4 > 1.6 under marlin 1.8. Everything works fine except the card which is well inserted but message "no data" (tested with 2 displays). SD card ok and...
View Article