Hello,
I would to like to connect the PS ON/green wire to my RAMPS1.4, so that I can programmatically switch on/off ATX PSU using M80 and M81 commands.
All the instructions I could find simply mention that I should connect the green wire to the pin "next to the reset switch". Well, that sounds easy enough, but I am still not 100% sure what to do and how to do it.
I took a picture of my RAMP1.4 and attached it here.
![]()
![]()
1. I believe what I have circled in blue is the reset button/switch (because there's a label that says "RESET" - as shown in the second picture).
2. There are pins left and right of this reset switch. So, which one of these is that pin "next to the reset switch"? Is it the one circled with red, or is it the one circled in yellow?
3. Lastly, I got one (green) wire coming out of ATX PSU. These pins have three connectors! Or, should I say these connectors have three pins?
Whatever the correct terminology is, to which pin/connector should I connect the green wire?
I would to like to connect the PS ON/green wire to my RAMPS1.4, so that I can programmatically switch on/off ATX PSU using M80 and M81 commands.
All the instructions I could find simply mention that I should connect the green wire to the pin "next to the reset switch". Well, that sounds easy enough, but I am still not 100% sure what to do and how to do it.
I took a picture of my RAMP1.4 and attached it here.
1. I believe what I have circled in blue is the reset button/switch (because there's a label that says "RESET" - as shown in the second picture).
2. There are pins left and right of this reset switch. So, which one of these is that pin "next to the reset switch"? Is it the one circled with red, or is it the one circled in yellow?
3. Lastly, I got one (green) wire coming out of ATX PSU. These pins have three connectors! Or, should I say these connectors have three pins?
Whatever the correct terminology is, to which pin/connector should I connect the green wire?