Hello fellow reprappers,
I am currently building my first reprap, and I'm having some problems.
I'm using RAMPS 1.4 with an Iduino Mega 2560.
Basically, I connected all the stepper motors, drivers, and boards together, and opened Pronterface. I can control the Z, X, Y motors, but when I try to get the extruder motor to move, nothing happens. I can't even hear any current going through the motor.
I tried adjusting the pot, and I've experimented a lot, so I'm pretty sure it's not the motor, the stepper driver, or the Mega.
I am using arduino 0023 with Sprinter.
I am stumped as to what's wrong. Any ideas? I don't know a whole lot about adjusting the firmware, so if there's a way to fix it that way that would be great.
Thank you in advance for your help.
3D-ME
I am currently building my first reprap, and I'm having some problems.
I'm using RAMPS 1.4 with an Iduino Mega 2560.
Basically, I connected all the stepper motors, drivers, and boards together, and opened Pronterface. I can control the Z, X, Y motors, but when I try to get the extruder motor to move, nothing happens. I can't even hear any current going through the motor.
I tried adjusting the pot, and I've experimented a lot, so I'm pretty sure it's not the motor, the stepper driver, or the Mega.
I am using arduino 0023 with Sprinter.
I am stumped as to what's wrong. Any ideas? I don't know a whole lot about adjusting the firmware, so if there's a way to fix it that way that would be great.
Thank you in advance for your help.
3D-ME