Hello everyone,
I built a Prusa i3 whit:
Motor Nema 17;
belt GT2 2mm
pulley 20 step
Electronic Arduino Mega2560 e ramps 1.4
ensd stop 4 wires with led;
firmware Merlin
Software Repetier
After wiring the electronics and the firmware is loaded (which I attached), the eletronica connect to the pc via usb, and the software can not connect without any error, but it happens that when I go to make the movements of the axes is not the case with fluidity, but with a sharp click. Also, when the mechanical stop switches hits do not stop, yet the LED switches are turned on.
I do not know how to resolve, can anyone help me !!!!
Thanks in advance
I built a Prusa i3 whit:
Motor Nema 17;
belt GT2 2mm
pulley 20 step
Electronic Arduino Mega2560 e ramps 1.4
ensd stop 4 wires with led;
firmware Merlin
Software Repetier
After wiring the electronics and the firmware is loaded (which I attached), the eletronica connect to the pc via usb, and the software can not connect without any error, but it happens that when I go to make the movements of the axes is not the case with fluidity, but with a sharp click. Also, when the mechanical stop switches hits do not stop, yet the LED switches are turned on.
I do not know how to resolve, can anyone help me !!!!
Thanks in advance